For electromechanics there’s a range of
pre-programmed functions:
 The Motomate interface allows you to program intuitively using graphic blocks.

 There are logic, GRAFCET (SFC), counter, clock, fast counter functions to name but a few…

 The functions dedicated to controlling movements and motors are pre-programmed and ready to use.

For automation specialists, Motomate’s
integrated PLC is a powerful tool:
 In addition to the selection of pre-programmed functions you can easily develop your specific programs using the PLCs integrated functions.

 You will have an open architecture that can communicate via fieldbus or modem to assist, for example, with remote maintenance.

 A highly flexible PLC.
You will be able to enhance or even modify your programs very easily – just using a PC. Sensors or actuators can also be added to the I/O.

	Timer Used to set a time delay between 2 movements
	Movement Used to reach a target position following speed ramps
	Motor multiplexer Used to group the On/Off, direction and speed outputs for several movement steps
	High speed counter Used to count motor pulses, indicate position and calculate speed

plus a whole host of other functions: